Diamond Gang Mower

Specifications:

• Gang Mower Diamond Frame: The ganging frames have a common unit frame. Owing to the frame, there are no upward projections, making the mowers to run under low hanging trees and ensuring that grass will not adhere to choke
• Gang Mower Diamond Chassis: Unbreakable, reinforced steel, firmly braced by axle and bottom block assembly
• Gang Mower Diamond Transmission: The cylinder is driven at both ends from road wheels through hardened steel machined cut gears, totally enclosed in an oil bath and ratchet drive to facilitate turning. Clutches fitted enables the cylinder to be taken out of gear and helps in transportation
• Gang Mower Diamond Gear Drive Type: All gears are fitted with bearing for longer life
• Cutting Cylinder: Blades running on heavy duty ball bearings
• Cutting Ratio: 1. At 08 Kph 1.0 Acre per hour/unit 2. At 08 Kph 3.0 acres per hour / 3 unit 3. At 10 Kph 1.4 acres per hour/ unit 4. At 10 Kph 4.2 acres per hour/3 unit. 5. At 16 Kph 2.0 acres per hour/unit 6. At 16 Kph 6.0 acres per hour / 3 unit
• Gang Mower Diamond Cutting Width: 1.1 unit - 76 cm (2ft 6in) 2.3 unit-2.10m (7ft 0in)
• Gang Mower Diamond Overall Width: 3.1 unit -1 22m (4ft 0in) 4. 3 unit-2.59m (8ft 6in)
• Gang Mower Diamond Overall Length: 1.1 unit - 81 cm (2ft 8in) 2. 3 unit-2.59m (8ft 6in)
• Gang Mower Diamond Clutch: A Clutch is fitted to each gearbox to engage the drive to the cutting cylinder Carriages: Unbreakable
• Gang Mower Diamond Adjustment: Cutting height can be adjusted from 1/2 to 8 inches
• Gang Mower Diamond Rear-Roll: Running on bearings on both sides
• Gang Mower Diamond Wheels: Pressed steel studded wheels specially fitted with double ball bearings
• Gang Mower Diamond Paint: Powder coated / liquid painted
• Gang Mower Diamond Cutting Speed Recommended: Depending upon the ground conditions, between 8-16 Kph where conditions are not so good it is recommended to reduce the speed to 5-8 Kph